HEADLAMP SURROUND MOLDING

Left headlamp surround moldings
(part number 12-46-1a)
$42

Right headlamp surround moldings
(part number 12-46-1b)
$42

Brand new aluminum Amphicar headlamp moldings-thin style. This moldings has the same profile as the original and is finished in bright dip anodizing. Each piece has been fitted to an actual Amphicar for a correct fit.

REAR LAMP SURROUND MOLDING

Brand new aluminum Amphicar rear lamp moldings-thin style. This moldings has the same profile as the original and is finished in bright dip anodizing. Each piece has been fitted to an actual Amphicar for a correct fit.

Left rear fender molding
(part number 12-46-3a)
$69

Right rear fender molding
(part number 12-46-3b)
$69

Brand new aluminum rear fin molding-thin style. This molding has the same profile as the original and is finished in bright dip anodized.

HOOD (TRUNK) MOLDING

Brand new aluminum Amphicar front hood molding. This molding has the same profile as the original and is finished in bright dip anodizing. Each piece has been fitted to an actual Amphicar for a correct fit.

ABOUT THIS MOLDING

Here is an alternative to the Stainless Steel molding soon to be available elsewhere. There were several thicknesses of molding made for the Amphicar. This is the thin style.

We started off by having a die designed to extrude the aluminum. Twenty foot long extrusions were made and the metal was annealed to make it soft for bending. Next, the pieces were formed with dies and bucks (forms). Each piece was then hand fitted to my project car. Also, two donated rear fins were mounted on stands and used to fit the long rear fender pieces. Pieces with extra long ends are also available if you feel your car is out of the norm and you don't mind trimming the ends. We then had the metal heat treated to put the strength (what little there is) back in. Lastly, the pieces have been polished and anodized in bright dip which was the original finish.